#Ios measure wifi signal strength how to

The dBm reading would be the number shown as Rx AGCO.LTE can be turned on again after viewing the dBm reading. Make sure that Enable LTE status is Off.Except iPhone X for all the models, first turn off LTE by going to Settings, then tap on Cellular, and go to Cellular Data Options.You can follow these steps in case you have an iPhone with Qualcomm chipset. Use Field Test Mode on Older Version of iOS on iPhone This will come into the picture if the main tower is out of service or not running. You will also need to search the nearest backup tower and its corresponding number for the rsrp1 (“reference signal obtained power”). Anything around -80 is deemed to be really fine, the -110 or below is said to be too bad. Note: “rsrpo” will be seen as negative and range from -40 to-130. It is the numerical measurement of your device’s cellular signal strength in dBm (decibel milliwatts). Now, you need to find “rsrp0” and check out the corresponding number.Tap on “LTE” and select “Serving Cell Meas”.

Your device will open the “Field test mode”.

Note: The same steps can be followed for AT&T or T-Mobile The first and the foremost thing to make sure is that your WiFi is turned off: Go to Settings → Wi-Fi → Turn off Wi-Fi. The below-mentioned steps should work for iOS 13 / iOS 12 / iOS 11.

#Ios measure wifi signal strength how to

How to Use iPhone Field Test Mode to See Your Cell Signal Strength How to Disable Field Test Mode on iPhone.How to Use iPhone Field Test Mode to See Your Cell Signal Strength.In this article, I will show how you can check the actual cell signal strength with the iPhone Field Test mode.

But whenever my phone starts displaying one or the other network problems, I take the help of “Field Test Mode” as signal bars do not help a lot when it comes to knowing the real signal power. Network problems are pretty common, and, particularly while traveling, these networks fluctuate a lot.